Captive Portal

Network Diagram:

Table of IP addresses

Device Name	IP addresses
Checkpoint Firewall	142.232.197.147/24
Client	192.168.1.224/24

Introduction

You should configure a source NAT on the Checkpoint firewall to allow the client to access the Internet. Next, implement a captive portal where clients must verify their credentials with a username and password before gaining Internet access.

Client Address : 192.168.1.224/24

Checkpoint Address: 142.232.197.147/24.

1. Load into the checkpoint firewall and set up default configuration. Establish the WAN connection.

2. Configure Source NAT to allow the client to access the Internet.

3. Enable and configure Browser Based Authentication (Captive Portal) so clients verify their credentials with a username and password before gaining Internet access.

4. Test Captive Portal by attempting to access the internet, which should be blocked by captive portal.

5.Client enters their credentials which grants them Internet access.

Team: Lorj, Sean, Jora, Hitesh, Dustyn